Time Between Attempts For Activating The Sensor; Msn Assignment For The Sensor - Siemens HiPath 1100 Programming Manual

Relay and sensor on the HiPath 1120
Step by step
did
dd
...
die
dde ehd
...
die
dde ehd
...
180
Time between attempts for activating the
sensor
This setting specifies a timeout after which a new at-
tempt is made to call an internal or external number, as-
suming that the line was busy on the previous attempt.
The default setting is 3 minutes.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
ed
Select a timeout until the next attempt (0 to 10 min-
utes).
w
Initial status for programming mode.

MSN Assignment for the Sensor

This settings specifies an MSN for the system to be
used for outgoing calls. By using this MSN, the called
party is able to identify the origin of the call. For in-
stance, this would be the case for an alarm.
The default configuration does not specify an MSN.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
Enter the slot for the MSN number.
w
Initial status for programming mode.
Delete
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
Enter the slot for the MSN number.
w
q
Press the key to remove it.
w
Initial status for programming mode.