Siemens HiPath 1100 Programming Manual page 25

Step by step
w
p
ehf
w
p
Enter the extension numbers (e.g., 11/101) or call
...
groups that should signal when receiving calls from the
specified external line (up to 10 extensions or 1 group).
w
r
Press this key.
Initial status for programming mode.
To assign an extension as an attendant for different
lines, repeat the programming steps.
Deleting attendants for an external line
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
p
Enter a number for an analog trunk (e.g., 801).
e h
Select the period of the day for answering calls:
...
e
= Day
f
= Night
g
= Day service, second attendant
h
= Night service, second attendant
w
q
The selected line attendant will be deleted.
r w
Press this key.
Initial status for programming mode.
If an extension is connected to a door opener de-
vice, the device cannot be configured as an at-
tendant.
Within a subscriber group an incoming call rings
at the first extension available, according to the
call distribution plan configured for the UCD sub-
scriber group.
When no first DID is configured, the call will be
forwarded to the Overflow extension. In the
event that an Overflow extension is not config-
ured, the call will end. In such cases no exten-
sion is signaled and the call cannot be captured.
Meanwhile, the system will continue to wait for
an available external line.
Important settings
25