Seizure Priority By Type Of External Line; Analog Trunk Seizure Protocol; Caller Id For Analog Lines - Siemens HiPath 1100 Programming Manual

Step by step
emh
dek

Seizure priority by type of external line

External lines can be accessed using Code 0 or the
code for the group of lines (e.g: 890). If the switch has
analog and digital lines, you can configure the type of
line that will be given priority.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
e g
Select the type of line:
...
e
= Independent seizure of the type of line (default).
f
= External digital lines are activated as first option.
g
= Analog trunks are activated as first option.
w
Initial status for programming mode.

Analog trunk seizure protocol

This feature specifies the protocol to be used by the
system for seizing an analog trunk, based on the local
carrier's information.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
p
Enter a number for an analog trunk (e.g., 801).
e f
Select the type of protocol:
...
e
= LOOP seizure (default for other countries)
f
= GROUND seizure (default for Canada)
w
r
Press this key.
Initial status for programming mode.

Caller ID for analog lines

In this case the seizure is sequential and cyclic.
When using the GROUND option for Canada, the
"Type of answering signal" feature for these ex-
ternal lines must be deactivated.
External line settings
43