Step by step
ekd
ekh
d
Sensor function configuration
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
d
g
Select the sensor's function:
...
d
= Deactivate the sensor function (default)
e
= Dial the number specified in "Number dialed by
f
= Enable the relay through the sensor
g
= Detect DTMF code. When this setting is select-
w
r
Press this key.
Initial status for programming mode.
Sensor activation logic
The main position of the sensor can be set as follows:
•
Contacts are closed. The sensor is activated when
contacts are open
•
Contacts are open. The sensor is activated when
contacts are closed
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
e
Select the main position for the sensor:
or
d
= Contacts closed (default)
e
= Contacts open
w
r
Press this key.
Initial status for programming mode.
Relay and sensor on the HiPath 1120
sensor activation" (Code 052).
ed, the number that was called must acknowl-
edge or ignore an alarm call by sending an
acknowledgement code ("#" DTMF signal)
179