Isdn Layer 1 - Siemens HiPath 1100 Programming Manual

Step by step
ede
de
dg
q

ISDN Layer 1

Allows you to change some default ISDN settings for
specified countries.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
df
, , Enter the S
ee
or
p
Enter the slot for the S
dd . de
port 00 is only used for the external line - PP or PMP);
dd . dh
dd . dh
module, place position 11 and port from 00 ... 04).
w
r
Activate/deactivate layer
or
q
= Activated
r
= Deactivated
w
Initial status for programming mode.
[1] Module slots are: HiPath 1120 (02), HiPath 1150 (03) and HiPath
1190 (01 and 11).
When there is an incoming call to an extension
activated for external call forwarding, the system
sends information about the call's new destina-
tion and the number of the forwarded extension
to the public network. This is done by means of
a call deflection activation message. The call is
forwarded over the public network, which means
that on theHiPath 1100, B channels are not need-
ed.
The local carrier can send to the HiPath 1100 in-
formation about the forwarded call billing.
If external call forwarding cannot be carried out
through Call Deflection to the public network, it
will be carried out by the system.
module slot on the system
0
module slot:
0
= For the HiPath 1120 (The slot for
= For the HiPath 1150;
= For the HiPath 1190 (For the second
Digital trunk settings
1
.
155