S0 Ports - Siemens HiPath 1100 Programming Manual

Step by step
djf
de
dg
de
dg
S ports
0
This setting specifies the operating mode for the S
module, maximizing the system's port usage.
This option is best for the HiPath 1190 due to its high
port capacity. The goal is to obtain the greatest possible
extension numbers/external lines allowed according to
the following port detection rules:
• External line and extension (default): Each port will
decrease the number of external line slots by 2 and
extension slots by 1. The connection may be PP ,
PMP or S
S0 Line").
• External line only: Each port will decrease the num-
ber of external line slots by 2. The connection must
be PP or PMP . If it has been previously configured as
S
0
versed to PP (which is the default).
• Extension only: Each port will decrease the exten-
sion number slots by 1. The connection must be a S
Bus line. If it has been previously configured as PP
or PMP , the connection will be automatically re-
versed to S
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
df
, , Dial the S
ee
or
e g
... Select an operating mode:
e
= External line and extension (default)
f
= External line only
g
= Extension only
df
, , Enter the next slot for the S
ee
or
or
[1] Module slots are: HiPath 1120 (02), HiPath 1150 (03) and HiPath
1190 (01 and 11).
Bus line (see item "Operation Mode for
0
Bus line, the connection will be automatically re-
Bus line.
0
After completing the configuration, the system
must be restarted.
module slot number on the system
0
Digital trunk settings
1
module.
0
0
0
.
149