Search Mode For Hunt Groups - Siemens HiPath 1100 Programming Manual

Programming an extension
Step by step
dfe
dff
e
66
w
r
Press this key.
Initial status for programming mode.
Deleting extensions from Hunt groups
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
p
Enter the Hunt group number (780 to 789)
w
q
Delete all extensions in the Hunt group.
w
r
Press this key.
Initial status for programming mode.

Search Mode for Hunt groups

This setting specifies how each Hunt group will conduct
a search for an available extension: linear search or
round-robin search.
• A linear search always starts from the first extension
in the group
• A round-robin search starts after the last extension
selected
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
p
Enter the Hunt group number (780 to 789).
w
f
or
Select the search mode:
e
= Linear (default)
f
= Cyclical
w
p
Enter the next Hunt group number.
or
w
r
Press this key.
Initial status for programming mode.
This feature only works for digital lines.