Siemens HiPath 1100 Programming Manual page 16

Features and options
System Telephones
(KS + optiPoint)
Digital line with TME1 / S
External analog lines
Digital line (TME1) + analog line/
digital line (S ) + analog line
0
[1] Each system telephone (KS) that is connected occupies one analog telephone slot.
[2] S and TME1 modules cannot be used simultaneously.
0
On the HiPath 1150 and HiPath 1190 ADSL and TME1 modules can be used simultaneously.
[3] When the maximum capacity for external lines is exceeded due to the installation of EB, S
the system deactivates analog trunks. Extension slots, however, continue to operate as usual.
Example 1: HiPath 1150
- Slot 0, MB 210,
- Slot 1, EB 210,
- Slot 3 TME1 - 30 digital lines
EB 210 external line will not work, but extensions will. Since the system allows for a maximum number of 32
lines we cannot have any additional analog line.
Example 2: HiPath 1150
- slot 0 MB 210
- slot 3 TME1 = 30 digital lines
In this case, there are 32 external lines at most available on the system. This means there is no room for an
additional EB module with an analog trunk.
30 CAS/S2 digital lines + 2 MB analog trunks = 32 external lines.
If an EB 200 were installed in slot 1 or slot 2 the module would not be operable, since it would exceed the sys-
tem's maximum capacity for external lines.
Example 3: HiPath 1150
- slot 0 MB 210
- slot 3 TME1 = 10 digital lines
(WARNING: Disable digital line for the TME1 Module and program unused digital lines on the switch as unavail-
able (turn the switch off then on).
Overall, there are 12 external lines on the system. This means there are 4 additional external lines available be-
fore reaching the maximum capacity of 16 external lines fo this combination.
An additional EB 400 could be used in Slot 1 or Slot 2.
If an EB 800 were installed on the switch, the entire module would be inoperable since it would exceed the
system's maximum capacity for external lines.
16
4 KS
8 optiPoint
(4 master + 4 slave)
0
8 KS
or +
16 optiPoint
(8 master +
8 Slave)
0/2 30/10
6 16
0/8 32/16
8 KS
+
16 optiPoint
(8 master +
8 Slave)
or
24 KS (CD 16
Module)
45/20
40
45/44
or TME1 modules,
0