Tme1 Module - Siemens HiPath 1100 Programming Manual

Digital trunk settings
Step by step
158
w
Initial status for programming mode.
This feature only works in ISDN lines in PP or
PMP mode and only with T-Reference Point.

TME1 module

The TME1 module can be configured to operate with E1
CAS access or S2 access. To determine the number of
analog and digital lines that will be available in the sys-
tem, see Service Manual - "Considerations for digital
lines in the HiPath 1150/1190".
The TME1 module is factory configured to oper-
ate as an E1 CAS interface.
In order for the module to work as a S2 interface
you must run a reconfiguration procedure using
the S2M Maintenance tool.
When the total number of digital trunks config-
ured for the module plus the number of analog
trunks exceeds the maximum capacity of the
system, the analog trunks for the EB 202, 206
and 210 expansion modules are deactivated.
Nevertheless, the extensions will continue to
work as usual. Lines are deactivated in the order
that they are physically installed (1, 2, etc.). This
process continues until the total number equals
the required number of trunks. The remaining
modules continue to operate as usual.
However, in the case of the EB 200, 400 and 800
modules, it is strongly recommended that you
change their slots to prevent their deactivation.
These modules become inoperable if any one of
their external line slots is deactivated.