Operation Mode For S0 Line - Siemens HiPath 1100 Programming Manual

Digital trunk settings
Step by step
emd
de
dg
e
150
w
r
Press this key.
Initial status for programming mode.
Operation Mode for S
This setting specifies the type of connection between
the S
0
nection can be Point-to-Point or Point-to-Multipoint or S
Bus.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
df
, , Enter the S
ee
or
.
p
Enter the physical position of the port on the S
dd . de
the Port 00 is only for the external line - PP or PMP)
dd .dh
dd .dh
module, place position 11 and port from 00 ... 04).
w
g
... Select the type of connection for the external digital
line.
e
= Point-to-Point (PP - default for the first port)
f
= Point-to-Multipoint (PMP)
g
= Bus S
p
Key in the physical slot of the port in the S
or
w
r
Press this key.
Initial status for programming mode.
[1] Module slots are: HiPath 1120 (02), HiPath 1150 (03) and HiPath
1190 (01 and 11).
Module digital lines and the local carrier. The con-
module slot on the system
0
= For the HiPath 1120 (The Position of
= For the HiPath 1150;
= For the HiPath 1190 (For the second
line call (default for all other ports)
0
With the HiPath 1120, the S
can only be a digital line, PP or PMP . It cannot be
programmed as an S
With other switches, the first port may also be
configured as an S
0
Line
0
1
.
module
0
module's first port
0
bus.
0
bus.
0
module
0