Time For Lcr Fallback; Acs (Alternative Carrier Selection) - Siemens HiPath 1100 Programming Manual

Important settings
Step by step
fie
di
40

Time for LCR fallback

This configures the routing time to the default carrier
defined in that rule of the LCR (See Manager - A31003-
K1160-M810-*, LCR).
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
gd
Enter the time for the exchange (from 05 to 30 sec-
...
onds). Default is 05 seconds.
w
Initial status for programming mode.

ACS (Alternative carrier selection)

If the system is programmed with the ACS (Alternative
carrier selection) option, you may define in the system
which route/destination the call should follow, indepen-
dently of the one selected by the user. This feature is
useful for choosing the route/destination with the
best rate when he call is actually made or for setting a
single route, once the conversion rules are duly pro-
grammed.
The first digits of the number dialed by the user are an-
alyzed by the system. If they match the conversion rule,
they will be replaced by the default number as set forth
by that rule. The route/destination to be used can also
be predetermined. There is no field available to specify
a carrier. The carrier code must be included in the con-
version rule.
Different conversion rules can be applied to the same
number, depending on the time of day and day of the
week. It is possible to define a maximum of 100 conver-
sion rules.
When a rule uses the overflow option, it may or
may not change the dialing rule.
Example: Number dialed: 262 XXXX
Conversion Rules: