Search Mode For Hunt Groups - Siemens HiPath 1100 Series Programming Manual

Programming an Extension
Step by Step
1
54
Deleting extensions from Hunt Groups
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 2 1
Enter the Hunt Group number (780 to 789)
* Delete all extensions in the Hunt Group.
Press this key.
#
Initial state for Programming Mode.

Search Mode for Hunt Groups

This setting specifies how each Hunt Group will
conduct a search for an available extension: linear or
round-robin search
• A linear search always starts from the first extension
in the group.
• A round-robin search starts after the last extension
selected.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 2 2
Enter the Hunt Group number (780 to 789).
or Select the search mode:
2
= Linear (default)
1
= Round-robin
2
Enter the next Hunt Group number
or
Press this key.
#
Initial state for Programming Mode.