Step by Step
1
*
Search Mode for Hunt Groups
This setting specifies how each Hunt Group will con-
duct a search for an available extension: linear or round-
robin search
•
A linear search always starts from the first extension
in the group
•
A round-robin search starts after the last extension
selected
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 2 2
Enter the Hunt Group number (780 to 789).
or
Select the search mode:
2
= Linear (default)
1
= Round-robin
2
Enter the next Hunt Group number.
or
#
Press this key.
Initial state for Programming Mode.
Call Forwarding within a Hunt Group (HG)
This feature works only on digital lines. It provides Call
Forwarding for extensions belonging to Hunt Groups.
When a call is directed to a group, it ring at each exten-
sion, according to the group settings (linear or round-
robin) When an extension is set for Call Forwarding,
calls are routed to the destination as configured. If a call
is not answered, the other extensions in that group do
not ring. When no Call Forwarding is set, calls ring at the
other extensions, as configured for the Hunt Group.
Required: Programming Mode must be active (*95
31994).
2 2 3
Enter the code for programming.
or
#
Activate/Deactivate Call Forwarding:
= To activate
*
= To deactivate (default)
#
Initial state for Programming Mode.
Programming an Extension
65