Vlan Commands - 3Com 3CRWEASYA73 / WL-575 User Manual

C 6: C L
HAPTER OMMAND INE
Example
AP (config)#iapp
AP (config)#

VLAN Commands

The access point can enable the support of VLAN-tagged traffic passing between
wireless clients and the wired network. Up to 64 VLAN IDs can be mapped to
specific wireless clients, allowing users to remain within the same VLAN as they
move around a campus site.
When VLAN is enabled on the access point, a VLAN ID (a number between 1 and
4094) can be assigned to each client after successful authentication using IEEE
802.1X and a central RADIUS server. The user VLAN IDs must be configured on
the RADIUS server for each user authorized to access the network. If a user does
not have a configured VLAN ID, the access point assigns the user to its own
configured native VLAN ID.
NOTE: When VLANs are enabled, the access point's Ethernet port drops all
received traffic that does not include a VLAN tag. To maintain network
connectivity to the access point and wireless clients, be sure that the access point
is connected to a device port on a wired network that supports IEEE 802.1Q VLAN
tags.
The VLAN commands supported by the access point are listed below.
Table 30 VLAN Commands
Command
vlan
management-
vlanid
vlan-id
I
NTERFACE
between access points from different vendors. This command is used to
enable or disable 802.11f handover signaling between different access
points, especially in a multi-vendor environment.
Function
Enables a single VLAN for all traffic
Configures the management VLAN for the access point GC
Configures the default VLAN for the VAP interface
6-178
Mode Page
GC 6-179
6-179
IC-W-VAP 6-180