Configuring Snmpv3 Groups; Configuring Snmpv3 Targets - 3Com 3CRWEASYA73 / WL-575 User Manual

C 5: S C
HAPTER YSTEM ONFIGURATION
C
This feature is display only and details the configured SNMPv3 groups configured.
Figure 25 Configuring SNMPv3 Groups
C
An SNMP v3 notification Target ID is specified by the SNMP v3 user, IP address,
and UDP port. A user-defined filter can also be assigned to specific targets to limit
the notifications received to specific MIB objects. (Note that the filter must first be
configured. see "Configuring SNMPv3 Trap Filters" on page 6-46)
To configure a new notification receiver target, click the New button. A new page
opens to configure the settings (see below). To edit an existing target, select the
radio button next to the entry in the table and then click the Edit button. To
delete targets, select the radio button next to the entry in the table and then click
the Delete button.
Figure 26 Configuring SNMPv3 Targets
Define the parameters and select a filter, if required. Click on the Add button to
save the configured parameters.
SNMP
ONFIGURING
SNMP
ONFIGURING
Target ID: A user-defined name that identifies a receiver of notifications. The
access point supports up to 10 target IDs. (Maximum length: 32 characters)
IP Address: Specifies the IP address of the receiving management station.
UDP Port: The UDP port that is used on the receiving management station for
notification messages.
SNMP User: The defined SNMP v3 user that is to receive notification messages.
3 G
V ROUPS
3 T
V ARGETS
5-28