3Com 3CRWEASYA73 / WL-575 User Manual page 85

New firmware file: Specifies the name of the code file on the local drive. The
new firmware file name should not contain slashes (\ or /), the leading letter of
the file name should not be a period (.), and the maximum length for file names
is 32 characters for files on the access point. (Valid characters: A-Z, a-z, 0-9, ".",
"-", "_")
Start Upgrade: Initiates the upgrade procedure.
Remote – Downloads an operation code image file from a specified remote FTP or
TFTP server. After filling in the following fields, click Start Upgrade to proceed.
Image Type: Specifies the type of file to upgrade. Stand-alone loads the new
firmware file on the unit.
FTP/TFTP: Specifies whether to use FTP or TFTP for file transfer.
New firmware file: Specifies the name of the code file on the server. The new
firmware file name should not contain slashes (\ or /), the leading letter of the
file name should not be a period (.), and the maximum length for file names is
32 characters for files on the access point. (Valid characters: A-Z, a-z, 0-9, ".",
"-", "_")
IP Address: IP address or host name of FTP or TFTP server.
Start Upgrade: Initiates the upgrade procedure.
Figure 35 Backing up and restoring user configuration settings
Backup and Restore Configuration – Uploads the current access point
configuration file to a specified remote TFTP server, or restores a previously stored
file of user configuration settings from a remote server.
FTP/TFTP: Specifies whether to use FTP or TFTP for file transfer.
5-37
Administration