3Com 3CRWEASYA73 / WL-575 User Manual page 46

C 4: I C
HAPTER NITIAL ONFIGURATION
3
Figure 9 Setup Wizard - Step 3
802.11a
Turbo Mode – If you select Enable, the access point will operate
in turbo mode with a data rate of up to 108 Mbps. Turbo mode
supports only 5 channels. (Default: Disabled)
802.11a Radio Channel – Set the operating radio channel
number.
Auto Channel Select – Select Enable for automatic radio
channel detection. (Default: Enabled)
802.11b/g
Turbo Mode - If you select Enable, the access point will operate in
turbo mode with a data rate of up to 108 Mbps. Normal mode support
11 channels, Turbo mode supports only 1 channel. (Default: Disabled)
802.11g Radio Channel - Set the operating radio channel number.
(Range 1-11)
IP Configuration – Either enable or disable Dynamic Host
Configuration Protocol (DHCP) for automatic IP configuration. If you
disable DHCP, then manually enter the IP address and subnet mask. If
a management station exists on another network segment, then you must
enter the IP address for a gateway that can route traffic between these
segments. Then enter the IP address for the primary and secondary Domain
Name Servers (DNS) servers to be used for host-name to IP address resolution.
DHCP Client – With DHCP Client enabled, the IP address, subnet mask and
default gateway can be dynamically assigned to the access point by the
network DHCP server. (Default: Disabled)
4-8