3Com 3CRWEASYA73 / WL-575 User Manual page 264

C 6: C L
HAPTER OMMAND INE
interface ethernet
This command enters Ethernet interface configuration mode.
Default Setting
Command Mode
Example
To specify the 10/100Base-TX network interface, enter the following command:
AP (config)#interface ethernet
AP (if-ethernet)#
dns server
This command specifies the address for the primary or secondary domain name
server to be used for name-to-address resolution.
Syntax
Default Setting
Command Mode
Command Usage
Example
This example specifies two domain-name servers.
AP (if-ethernet)#dns primary-server 192.254.2.55
AP (if-ethernet)#dns secondary-server 10.1.0.55
AP (if-ethernet)#
I
NTERFACE
None
Global Configuration
dns primary-server <server-address>
dns secondary-server <server-address>
• primary-server - Primary server used for name resolution.
• secondary-server - Secondary server used for name resolution.
• server-address - IP address of domain-name server.
None
Global Configuration
The primary and secondary name servers are queried in sequence.
6-132