C
6: C
L
HAPTER
OMMAND
INE
rogue-ap interval
This command sets the interval at which to scan for access points.
Syntax
Default Setting
Command Mode
Command Usage
Example
AP (if-wireless g)#rogue-ap interval 120
AP (if-wireless g)#
Related Commands
rogue-ap scan
This command starts an immediate scan for access points on the radio interface.
Default Setting
Command Mode
Command Usage
I
NTERFACE
rogue-ap interval <minutes>
minutes - The interval between consecutive scans. (Range: 30-10080
minutes)
720 minutes
Interface Configuration (Wireless)
This command sets the interval at which scans occur. Frequent scanning will
more readily detect other access points, but will cause more disruption to
client access.
rogue-ap duration (6-161)
Disabled
Interface Configuration (Wireless)
While the access point scans a channel for rogue APs, wireless clients will
not be able to connect to the access point. Therefore, avoid frequent
scanning or scans of a long duration unless there is a reason to believe that
more intensive scanning is required to find a rogue AP.
6-162