Interface; Configuring Radio Settings - 3Com 3CRWEASYA73 / WL-575 User Manual

802.11 I
A NTERFACE
The IEEE 802.11a interface operates within the 5 GHz band, at up to 54 Mbps in
normal mode or up to 108 Mbps in Turbo mode.
First configure the radio settings that apply to the individual VAPs (Virtual Access
Point) and the common radio settings that apply to the overall system. After you
have configured the radio settings, go to the Security page under the 802.11a
Interface (See "Security" on page 68.), enable the radio service for any of the VAP
interfaces, and then set an SSID to identify the wireless network service provided
by each VAP. Remember that only clients with the same SSID can associate with a
VAP.
NOTE: You must first select a country before the wireless interfaces are enabled.

Configuring Radio Settings

To configure VAP radio settings, select the Radio Settings page.
Figure 45 Radio Settings A
Radio Status – Displays if the radio is enabled or disabled for this VAP.
NOTE: You must first enable VAP interface 1 before you can enable other VAP
interfaces.
SSID – The name of the basic service set provided by a VAP interface. Clients that
want to connect to the network through the access point must set their SSID to
the same as that of an access point VAP interface. (Default: 3Com1 to 3Com4 for
802.11a, 3Com5 to 3Com8 for 802.11b/g; Range: 1-32 characters)
5-55
Radio Interface