Configuring Common Radio Settings - 3Com 3CRWEASYA73 / WL-575 User Manual

First configure the radio settings that apply to the individual VAPs (Virtual Access
Point) and the common radio settings that apply to all of the 802.11g interfaces.
After you have configured the radio settings, enable the radio service for any of
the VAP interfaces, and then set an SSID to identify the wireless network service
provided by each VAP. Remember that only clients with the same SSID can
associate with a VAP.
NOTE: You must first select a country of operation before interfaces can be
enabled.
Most of the 802.11g commands are identical to those used by the 802.11a
interface. For information on the these commands, refer to the following
sections:
"Configuring Radio Settings" on page 55
"Rogue AP" on page 30
"Configuring Common Radio Settings" on page 57
"Wi-Fi Protected Access (WPA)" on page 75
Only the radio settings specific to the 802.11g interface are included in this
section. To configure the 802.11g radio settings, select the Radio Settings page.
5-61
Radio Interface