3Com 3CRWEASYA73 / WL-575 User Manual page 210

C 6: C L
HAPTER OMMAND INE
Default Setting
Command Mode
Command Usage
Example
AP (config)#snmp-server host 1 10.1.19.23 batman
AP (config)#
Related Commands
snmp-server trap
This command enables the access point to send specific SNMP traps
(i.e., notifications). Use the no form to disable specific trap messages.
Syntax
I
NTERFACE
• host_name - Name of the host. (Range: 1-63 characters)
• community-string - Password-like community string sent with the
notification operation. Although you can set this string using the
snmp-server host command by itself, we recommend that you define
this string using the snmp-server community command prior to using
the snmp-server host command. (Maximum length: 23 characters)
Host Address: None
Community String: public
Global Configuration
The snmp-server host command is used in conjunction with the
snmp-server enable server command to enable SNMP notifications.
snmp-server enable server (6-77)
snmp-server trap <trap>
no snmp-server trap <trap>
• trap - One of the following SNMP trap messages:
- dot11InterfaceAFail - The 802.11a or 802.11g interface has failed.
- dot11InterfaceGFail - The 802.11b/g interface has failed.
- dot11StationAssociation - A client station has successfully associated
with the access point.
- dot11StationAuthentication - A client station has been successfully
authenticated.
- dot11StationReAssociation - A client station has successfully
re-associated with the access point.
6-78