C
6: C
L
HAPTER
OMMAND
INE
Command Mode
Example
AP (config)#ip http server
AP (config)#
Related Commands
ip https port
Use this command to specify the UDP port number used for HTTPS/SSL
connection to the access point's Web interface. Use the no form to restore the
default port.
Syntax
Default Setting
Command Mode
Command Usage
Example
AP (config)#ip https port 1234
AP (config)#
I
NTERFACE
Global Configuration
ip http port (6-19)
ip https port <port_number>
no ip https port
port_number – The UDP port used for HTTPS/SSL.
(Range: 80, 1024-65535)
443
Global Configuration
• You cannot configure the HTTP and HTTPS servers to use the same port.
• To avoid using common reserved TCP port numbers below 1024, the
configurable range is restricted to 443 and between 1024 and 65535.
• If you change the HTTPS port number, clients attempting to connect to the
HTTPS server must specify the port number in the URL, in this format:
https://device:port_number
6-20