Filtering By Vlan; Security Filters; Filtering By Ethernet Protocol Type - 3Com 3CRWE870075A - Wireless LAN Access Point 8700 User Manual

F VLAN
ILTERING BY
The access point supports filtering of up to 64 VLANs (virtual local area networks).
The VLAN IDs must be configured for each client on one of the servers specified
on the RADIUS configuration page.
When VLAN filtering is enabled, the access point queries the server for the
VLAN IDs of associating clients and saves the VLAN IDs. If a client does not have a
VLAN ID, the access point assigns its own native VLAN ID to that client.
To enable VLAN filtering, enter a VLAN ID (a number between 1 and 4095) in the
Native VLAN ID field and select VLAN Enable.
When VLAN filtering is disabled, the access point ignores VLAN-tagged frames.
S F
ECURITY ILTERS
These options allow you to block communication among wireless clients
(client-to-client blocking) and prevent wireless clients from performing access
point administration.
Local Bridge Filter—Enable this filter to prevent direct communication
I
between wireless clients, creating a more secure wireless network.
AP Management Filter—Enable this filter to prevent wireless clients from
I
accessing the access point for management; for example through TELNET or
SNMP.
F E
ILTERING BY THERNET
Use the Ethernet Type Filter table to filter out Ethernet packet frames that match
the Ethernet protocol type. Select Ethernet Type Filter Enable, then set the status
of each Ethernet frame type in the list.
Although there are five types of IPX packets, the Filter Control page shows only
two options for IPX filtering. The following table shows how to filter each IPX
packet type:
ISO Designator
8138
8137
802.3(Raw)
802.2
SNAP
P T
ROTOCOL
Filter
Enable 8138
Enable 8137
Enable 8138
Enable 8138
Enable 8137
32
YPE