Filter Control; Filtering By Vlan - 3Com WL-455 User Manual

Parameter
System Default
MAC Address
Permission
Update button
F C
ILTER ONTROL
The Filter Control page allows you to control client communication within the wireless
network. You may enable one or more types of supported filtering; however, some
filter choices may supersede others. Configure the options as described below. When
you are finished, click Apply.
F
The access point supports filtering of up to 64 VLANs (virtual local area networks).
VLAN IDs must be configured for each client on one of the RADIUS authentication
servers specified on the RADIUS configuration page. If a RADIUS server is not being
used or not setup to update the VLAN ID, then the access point will tag all ethernet
packets with the Native VLAN ID (defaulted to 1).
If a RADIUS authentication server will be used to create/modify the VLAN ID, the
following attributes must be provisioned on the RADIUS Server to be passed back to
the authenticating client:
VLAN
ILTERING BY
The AP's IP address is the RADIUS Client/Radius User
Tunnel_type (64) = VLAN (13)
Tunnel_Medium_type (65) = 802
Description
Define the default filtering setting as Deny or Allow.
Enter the MAC address of a client for the access control. You can
find the MAC address of a network card as follows:
Windows 95/98/ME—Click Start/Run. Type winipcfg and press
Enter. The MAC address is in the Adapter Address section.
Windows NT4/2000/XP—At the command prompt, type
ipconfig /all and press Enter. The MAC address is listed as the
Physical Address.
Linux—Run the command "/sbin/ipconfig." The card's MAC
address is the value after the word "HWaddr."
Allows or denies access to the access point of devices matching
the specified MAC address.
Click Update to refresh the MAC Authentication Table. To avoid
the possibility of entering an invalid MAC address on the
Authentication page, always click Update after typing the
address. If you press Enter, address error checking does
not occur.
33