3Com 3CRWEASYA73 / WL-575 User Manual page 150

C 6: C L
HAPTER OMMAND INE
Command Usage
Example
AP(if-ethernet)#ip ssh-server enable
AP(if-ethernet)#
ip ssh-server port
This command sets the Secure Shell server port. Use the no form to disable the
server.
Syntax
Default Setting
Command Mode
Example
AP(if-ethernet)#ip ssh-server port 1124
AP(if-ethernet)#
ip telnet-server enable
This command enables the Telnet server. Use the no form to disable the server.
Syntax
Default Setting
I
NTERFACE
• The access point supports Secure Shell version 2.0 only.
• After boot up, the SSH server needs about two minutes to generate host
encryption keys. The SSH server is disabled while the keys are being
generated. The show system command displays the status of the SSH
server.
ip ssh-server port <port-number>
• port-number - The UDP port used by the SSH server. (Range: 1-65535)
22
Interface Configuration (Ethernet)
ip telnet-server enable
no ip telnet-server
Interface enabled
6-18