Removing The Rack Mounting Frame - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

Basic hardware procedures
Ê Remove the ID card from the server.
I
It may be necessary to pull out on the ID card rather firmly. However,
do not apply excessive force.
4.5.1.3

Removing the rack mounting frame

I
The rack front cover consists of a plastic frame and two rack mounting
brackets. For further information, refer to section
front cover" on page
Ê Pull out the ID card from the server front as described in section
the ID card" on page
Figure 15: Removing the rack mounting frame (A)
Ê Remove two screws from the side brackets on either side of the rack
mounting frame.
70
729.
69.
Upgrade and Maintenance Manual
"Assembling the rack
"Removing
TX300 S8 / RX350 S8