Installing Hdd Modules Into The 4X 3.5-Inch Hdd Extension Box - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

Hard disk drives / solid state drives
7.4.5.6

Installing HDD modules into the 4x 3.5-inch HDD extension box

"Closing the server" on page 98
Ê
Ê Install HDD modules or HDD dummy modules into the additional HDD slots
as described in sections
and "Installing a 3.5-inch HDD dummy module" on page
I
For detailed information on HDD mounting order, refer to section
inch HDD configurations" on page
7.4.5.7 Concluding steps
"Installing the system fan holder" on page 331
Ê
"Installing the system air duct" on page 83
Ê
"Closing the server" on page 98
Ê
Ê When working on a rack-mounted server:
"Mounting the server in the rack" on page 115
"Connecting the server to the mains" on page 118
Ê
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task:
7.4.6 Removing the 4x 3.5-inch HDD extension box
Upgrade and Repair Unit
(URU)
Tools: tool-less
7.4.6.1 Preliminary steps
"Suspending BitLocker functionality" on page 125
Ê
"Shutting down the server" on page 62
Ê
"Disconnecting the server from the mains" on page 63
Ê
Ê Remove all HDD modules from the HDD extension box as described in
section "Removing 3.5-inch HDD modules" on page
298
"Installing a 3.5-inch HDD module" on page 256
"Resuming BitLocker functionality" on page 152
Upgrade and Maintenance Manual
261.
241.
Average task duration:
10 minutes
258.
TX300 S8 / RX350 S8
"3.5-