Preliminary Steps - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

Hard disk drives / solid state drives
7.5.1.1

Preliminary steps

"Suspending BitLocker functionality" on page 125
Ê
"Shutting down the server" on page 62
Ê
"Disconnecting the server from the mains" on page 63
Ê
Ê When working on a rack-mounted server:
"Extending / removing the server from the rack" on page 64
"Opening the server" on page 68
Ê
"Removing the system air duct" on page 81
Ê
"Removing the system fan holder" on page 330
Ê
7.5.1.2 Installing SAS expander board spacer bolts
Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver
I
This step is only necessary if SAS expander board spacer bolts are not
already mounted in the system. Otherwise, please proceed to section
"Installing the SAS expander board" on page
Ê Remove the system board as described in section
board" on page
Ê Remove the system board carrier as described in section
system board carrier" on page
310
687.
85.
Upgrade and Maintenance Manual
Average task duration:
additional 30 minutes
312.
"Removing the system
"Removing the
TX300 S8 / RX350 S8