Replacing Processor Heat Sinks - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

11.5.4 Replacing processor heat sinks

11.5.4.1 Removing the processor heat sink
Ê Remove the processor heat sink as described in section
processor heat sinks" on page
11.5.4.2 Applying thermal paste
Ê Apply thermal paste to the processor surface as described in section
"Applying thermal paste" on page
I
If the processor upgrade or replacement kit contains a new CPU heat
sink, a thin layer of thermal compound has already been pre-applied
to its lower surface. In this case, please proceed with section
"Installing the processor heat sink" on page
11.5.4.3 Installing the processor heat sink
Ê Install the processor heat sink as described in sections
sink and processor" on page 520
11.5.5 Concluding steps
"Installing the system air duct" on page 83
Ê
"Closing the server" on page 98
Ê
Ê When working on a rack-mounted server:
"Mounting the server in the rack" on page 115
"Connecting the server to the mains" on page 118
Ê
TX300 S8 / RX350 S8
523.
526.
and
Upgrade and Maintenance Manual
525.
"Installing the heat sink" on page
Processors
"Removing
"Preparing the heat
521.
525