Installing A New Fbu Module - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

Expansion cards and backup units
Figure 354: Removing the FBU from the FBU holder
Ê At a slight angle, slide the FBU from under the retaining brackets of the FBU
holder and remove it.
9.6.7.4

Installing a new FBU module

Ê Install the new FBU into the FBU holder as described in section
the FBU" on page
Ê Install the FBU holder into the chassis as described in section
FBU holder into the chassis" on page
Ê Connect the FBU to the controller.
462
447.
Upgrade and Maintenance Manual
449.
"Preparing
"Installing the
TX300 S8 / RX350 S8