Concluding Steps; Upgrading To 8X 3.5-Inch Hdd Configurations; Preliminary Steps - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

Hard disk drives / solid state drives
Ê Secure the HDD bay top cover to the chassis with five M3 x 4.5 mm screws
(see blue arrows).
Ê Secure the intrusion switch holder on the HDD bay top cover with one
M3 x 4.5 mm screw (see orange arrow).
7.3.9.6

Concluding steps

"Installing the system fan holder" on page 331
Ê
"Installing the system air duct" on page 83
Ê
"Closing the server" on page 98
Ê
Ê Install HDD / SSD modules or HDD dummy modules into the additional HDD
slots as described in sections
page 256 and
I
For detailed information on HDD mounting order, refer to section
inch HDD configurations" on page
Ê When working on a rack-mounted server:
"Mounting the server in the rack" on page 115
"Connecting the server to the mains" on page 118
Ê

7.3.10 Upgrading to 8x 3.5-inch HDD configurations

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver

7.3.10.1 Preliminary steps

"Suspending BitLocker functionality" on page 125
Ê
"Shutting down the server" on page 62
Ê
"Disconnecting the server from the mains" on page 63
Ê
Ê Remove all HDD modules from the server as described in section
"Removing 3.5-inch HDD modules" on page
272
"Installing a 3.5-inch HDD module" on
"Installing a 3.5-inch HDD dummy module" on page
Upgrade and Maintenance Manual
241.
Average task duration:
20 minutes
258.
TX300 S8 / RX350 S8
261.
"3.5-