Removing A Processor - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

"Removing the system air duct" on page 81
Ê
"Removing processor heat sinks" on page 523
Ê

11.3.2 Removing a processor

I
This description applies to the following procedures:
– Removing CPU 2 from a dual-processor configuration
– Removing CPUs from a defective system board (see section
"Swapping processors" on page
Ê Remove the desired processor heat sink as described in section
processor heat sinks" on page
Figure 375: Opening socket release lever 1
Ê Unlatch the socket release lever marked Open 1st by pushing it down and
away from the socket (1).
Ê The socket release lever will slightly lift up (2).
TX300 S8 / RX350 S8
523.
Upgrade and Maintenance Manual
695)
Processors
"Removing
497