Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual page 50

Important information
As a precaution, remove disks from the optical disk drive when the
●
drive is not to be used for a long time. Keep the optical disk tray
closed to prevent foreign matter, such as dust, from entering the
optical disk drive.
Hold CDs/DVDs/BDs by their edges to avoid contact with the disk
●
surface.
Do not contaminate the CD/DVD/BD surface with fingerprints, oil,
●
dust, etc. If dirty, clean with a soft, dry cloth, wiping from the center to
the edge. Do not use benzene, thinners, water, record sprays,
antistatic agents, or silicone-impregnated cloth.
Be careful not to damage the CD/DVD/BD surface.
●
Keep the CDs/DVDs/BDs away from heat sources.
●
Do not bend or place heavy objects on CDs/DVDs/BDs.
●
Do not write with ballpoint pen or pencil on the label (printed) side.
●
When a CD/DVD/BD is moved from a cold place to a warm place,
●
moisture condensation on the CD/DVD/BD surface can cause data
read errors. In this case, wipe the CD/DVD/BD with a soft, dry cloth
then let it air dry. Do not dry the CD/DVD/BD using devices such as a
hair dryer.
To avoid dust, damage, and deformation, keep the CD/DVD/BD in its
●
case whenever it is not in use.
Do not store CDs/DVDs/BDs at high temperatures. Areas exposed to
●
prolonged direct sunlight or near heating appliances are to be
avoided.
I
You can prevent damage from the optical disk drive and the
CDs/DVDs/BDs, as well as premature wear of the disks, by observing
the following suggestions:
– Only insert disks in the drive when needed and remove them after
use.
– Store the disks in suitable sleeves.
– Protect the disks from exposure to heat and direct sunlight.
50 Upgrade and Maintenance Manual
TX300 S8 / RX350 S8