Removing A 3.5-Inch Hdd Dummy Module - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

7.3.6.2

Removing a 3.5-inch HDD dummy module

Figure 161: Removing a 3.5-inch dummy module
I
Dummy modules have been installed into unused HDD bays. Before
installing an additional HDD, the dummy module needs to be removed
from the desired drive bay.
Ê Press in on the locking tabs on both sides of the dummy module to
disengage the locking mechanism (1).
Ê While keeping the locking tabs pressed, pull the dummy module out of its
bay (2).
V
CAUTION!
Save the dummy module for future use.
Always replace dummy modules into unused HDD bays to comply
with applicable EMC regulations and satisfy cooling requirements.
TX300 S8 / RX350 S8
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
255