Installing The Ufm Board - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

14.1.4 Concluding steps
Ê Dispose of the CMOS battery in accordance with local regulations
concerning special waste.
"Installing the system air duct" on page 83
Ê
"Closing the server" on page 98
Ê
Ê When working on a rack-mounted server:
"Mounting the server in the rack" on page 115
"Connecting the server to the mains" on page 118
Ê
Ê Verify whether the backup data on the Chassis ID EPROM has been
restored to the system board as described in section
information backup / restore" on page
"Verifying the system time settings" on page 148
Ê
14.2 USB Flash Module (UFM)
This section provides information on how to install, remove or replace the USB
Flash Module (UFM).

14.2.1 Installing the UFM board

Upgrade and Repair Unit
(URU)
Tools: tool-less
14.2.1.1 Preliminary steps
"Suspending BitLocker functionality" on page 125
Ê
"Disabling SVOM boot watchdog functionality" on page 127
Ê
"Locating the defective server" on page 57
Ê
"Shutting down the server" on page 62
Ê
TX300 S8 / RX350 S8
Upgrade and Maintenance Manual
System board and components
"Verifying system
136.
Average task duration:
10 minutes
649