Removing Processors - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

Processors
Ê If available, update the system board BIOS and the iRMC to the latest
version as described in section
BIOS and iRMC" on page
"Enabling SVOM boot watchdog functionality" on page 146
Ê
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task:
11.3

Removing processors

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
V
CAUTION!
Processors are extremely sensitive to electrostatic discharge and must
be handled with care. After a processor has been removed from its
protective sleeve or from its socket, place it upside down on a
nonconducting, antistatic surface. Never push a processor over a
surface.
11.3.1 Preliminary steps
"Suspending BitLocker functionality" on page 125
Ê
"Disabling SVOM boot watchdog functionality" on page 127
Ê
"Shutting down the server" on page 62
Ê
"Disconnecting the server from the mains" on page 63
Ê
Ê When working on a rack-mounted server:
"Extending / removing the server from the rack" on page 64
Ê Bring the server to its horizontal position.
Ê Open the side / top cover as described in section
page 68.
496
"Updating or recovering the system board
134.
"Resuming BitLocker functionality" on page 152
Upgrade and Maintenance Manual
Average task duration:
20 minutes
"Opening the server" on
TX300 S8 / RX350 S8