Installing Accessible Drive Dummy Covers - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

Ê Pull the LSD module out of the 3.5-inch installation frame (2).
Ê If the removed LSD module is not to be replaced by a new module, reinstall
the LSD dummy cover.

12.5.2.5 Installing accessible drive dummy covers

I
if the 4x 3.5-inch HDD extension box is to be reinstalled in the system,
the following description does not apply. Please proceed as described in
section "Installing the 4x 3.5-inch HDD extension box" on page
Installing accessible drive filler covers
Ê Install an accessible drive filler cover (C26361-K644-C933) into the empty
installation bay 1 as described in section
page 94.
V
CAUTION!
Always replace filler covers into unused drive bays to comply with
applicable EMC regulations and satisfy cooling requirements.
Installing accessible drive covers
Ê Install an accessible drive cover (C26361-K644-C60) into installation bay 1
of the front cover as described in section
page 96.
12.5.2.6 Concluding steps
"Installing the system fan holder" on page 331
Ê
"Installing the system air duct" on page 83
Ê
"Closing the server" on page 98
Ê
Ê When working on a rack-mounted server:
"Mounting the server in the rack" on page 115
"Connecting the server to the mains" on page 118
Ê
TX300 S8 / RX350 S8
Upgrade and Maintenance Manual
Accessible drives
"Accessible drive filler covers" on
"Accessible drive covers" on
296.
567