Removing The Power Backplane - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

Power supply
Ê Remove all rear expansion cards from the system board as described in
section "Removing expansion cards" on page
I
Ensure to take note of the expansion cards' mounting positions and
cable connections for reassembly.
The following components may remain on the system board:
– Heat sink and processors
– Memory modules
– UFM board
– TPM boards
"Removing the system board" on page 687
Ê
"Removing the system board carrier" on page 85
Ê
6.5.2

Removing the power backplane

Figure 84: Disconnecting cables from the power backplane
Ê Disconnect all cables from the power backplane.
176 Upgrade and Maintenance Manual
357.
TX300 S8 / RX350 S8