Removing The System Board - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

14.6.2 Removing the system board

Ê Remove all cables from the system board.
Ê Remove the following components from the system board as shown in the
related sections:
– Heat sink: see
I
Leave the processor on the defective board for now.
– Memory modules: refer to section
page 479
I
Ensure to take note of the memory modules' mounting positions
for reassembly.
– Expansion cards: refer to the section
page 357
I
Ensure to take note of the controllers' mounting positions and
cable connections for reassembly.
– UFM board: refer to section
I
Remove the UFM spacer from the defective system board and
fasten it to the UFM board with the UFM screw.
– Onboard SAS enabling key: refer to section
enabling key" on page 678
– iRMC microSD card: refer to section
on page 681
TX300 S8 / RX350 S8
section "Removing processor heat sinks" on page 523
"Removing the UFM board" on page 653
Upgrade and Maintenance Manual
System board and components
"Removing memory modules" on
"Removing expansion cards" on
"Replacing the onboard SAS
"Removing the iRMC microSD card"
687