Replacing The Slimline Odd - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

12.7.3 Replacing the slimline ODD

Upgrade and Repair Unit
(URU)
Tools: – Phillips PH2 / (+) No. 2 screw driver
– Slotted screw driver (for bending in or out accessible drive
mounting brackets)
12.7.3.1 Preliminary steps
"Locating the defective server" on page 57
Ê
"Removing backup and optical disk media" on page 129
Ê
"Shutting down the server" on page 62
Ê
"Disconnecting the server from the mains" on page 63
Ê
Ê When working on a rack-mounted server:
"Extending / removing the server from the rack" on page 64
Ê Open the side / top cover as described in section
page 68.
I
Removing the front cover is not required in order to replace the
slimline ODD or LSP in the 2x 3.5-inch HDD extension box.
"Removing the system air duct" on page 81
Ê
"Removing the system fan holder" on page 330
Ê
12.7.3.2 Removing the 4x 3.5-inch HDD extension box
Ê Remove all cables from the 4x 3.5-inch HDD extension box backplane.
Ê Remove all cables from the slimline ODD.
Ê Remove the 4x 3.5-inch HDD extension box from the server as described in
section "Removing the 4x 3.5-inch HDD extension box" on page
TX300 S8 / RX350 S8
Upgrade and Maintenance Manual
Accessible drives
Average task duration:
10 minutes
"Opening the server" on
299.
599