Replacing The Sas Raid Controller - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

Expansion cards and backup units
9.5.3.3 Concluding steps
"Installing the system air duct" on page 83
Ê
"Closing the server" on page 98
Ê
Ê When working on a rack-mounted server:
"Mounting the server in the rack" on page 115
"Connecting the server to the mains" on page 118
Ê
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task:
9.5.4

Replacing the SAS RAID controller

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
9.5.4.1 Preliminary steps
"Suspending BitLocker functionality" on page 125
Ê
"Disabling SVOM boot watchdog functionality" on page 127
Ê
"Locating the defective server" on page 57
Ê
"Shutting down the server" on page 62
Ê
"Disconnecting the server from the mains" on page 63
Ê
Ê When working on a rack-mounted server:
"Extending / removing the server from the rack" on page 64
Ê Bring the server to its horizontal position.
Ê Open the side / top cover as described in section
page 68.
"Removing the system air duct" on page 81
Ê
Ê Locate the defective expansion card using the onboard Local Diagnostic
LEDs as described in section
page 779.
432
"Resuming BitLocker functionality" on page 152
"Onboard indicators and controls" on
Upgrade and Maintenance Manual
Average task duration:
15 minutes
"Opening the server" on
TX300 S8 / RX350 S8