Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual page 706

System board and components
Figure 552: Connecting cables to the system board (C)
Ê Run the SAS and intrusion switch cables through the cable clamps (C) on
the HDD cage and the cable guide (G) as shown.
Ê Connect the SAS cable (if applicable for your configuration) and intrusion
switch cable to the system board.
I
For further information on SAS backup drive cabling, refer to section
"SAS backup drives with separate power supply" on page
Cable
No.
(T26139-)
Intrusion switch
6 cable
Y3922-V121
SAS cable (4x 3.5"
HDD configurations
7
only) or SAS backup
drive cable
1
Requires installed Onboard SAS enabling key (see section
enabling key" on page
706
Cabling
from
list no.
Intrusion switch
13
holder
15-18 Power backplane
7 connector X25
673)
Upgrade and Maintenance Manual
543.
Cabling
to
plan
System board
connector
INTRUSION
System board
connector
1
SAS 1-4
"Installing the onboard SAS
TX300 S8 / RX350 S8
16.2.1
16.2.1