Concluding Steps - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

Expansion cards and backup units
9.3.3.4

Concluding steps

"Installing the system air duct" on page 83
Ê
"Closing the server" on page 98
Ê
Ê When working on a rack-mounted server:
"Mounting the server in the rack" on page 115
Ê Reconnect all external cables to the replaced expansion card.
"Connecting the server to the mains" on page 118
Ê
Ê Enable the PCI slot of the replaced expansion card as described in section
"Enabling replaced components in the system BIOS" on page
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section
on page 153.
Ê After replacing a network controller in a server running Linux OS, update its
MAC address in the related NIC definition file as described in section
"Updating the NIC configuration file in a Linux environment" on page
"Enabling SVOM boot watchdog functionality" on page 146
Ê
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task:
Ê Reconfigure your network settings in the operation system according to the
original configuration of the replaced controller (expansion card or onboard).
I
Configuration of network settings should be performed by the
customer.
For further information, please refer to section
settings recovery" on page
Ê If applicable, restore LAN teaming configurations as described in section
"After replacing / upgrading LAN controllers" on page
380
"Looking up changed MAC / WWN addresses"
"Resuming BitLocker functionality" on page 152
378.
Upgrade and Maintenance Manual
147.
150.
"Note on network
157.
TX300 S8 / RX350 S8