Usb Flash Module (Ufm); Installing The Ufm Board; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

System board and components
14.2

USB Flash Module (UFM)

This section provides information on how to install, remove or replace the USB
Flash Module (UFM).

14.2.1 Installing the UFM board

Field Replaceable Units (FRU)
Average hardware task duration: 5 minutes
Average software task duration: 5 minutes

14.2.1.1 Required tools

Preliminary and concluding steps: tool-less
●
Installing the UFM:
●
– Phillips PH1 / (+) No. 1 screw driver

14.2.1.2 Preliminary steps

Before installing the UFM board, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Disable boot watchdog functionality as described in section
SVOM boot watchdog functionality" on page
Ê If applicable, open the rack door as described in section
door" on page
Ê Locate the desired server as described in section
server" on page
Ê Shut down the server as described in section
page 61.
422
93.
61.
54.
Upgrade and Maintenance Manual
"Disabling BitLocker
"Disabling
94.
"Opening the rack
"Locating the defective
"Shutting down the server" on
TX140 S1