Replacing A Slimline Odd Or Lsd; Preliminary Steps; Removing The Defective Slimline Odd; Removing The Defective Lsd Module - Fujitsu PRIMERGY TX150 S8 Upgrade And Maintenance Manual

12.5.3 Replacing a slimline ODD or LSD

Upgrade and Repair Unit
(URU)
Tools: – Phillips PH2 / (+) No. 2 screw driver
– Slotted screw driver (for bending in or out accessible drive
mounting brackets)

12.5.3.1 Preliminary steps

"Locating the defective server" on page 47
Ê
"Removing backup and optical disk media" on page 82
Ê
"Shutting down the server" on page 50
Ê
"Disconnecting the server from the mains" on page 50
Ê
"Getting access to the component" on page 51
Ê
I
Removing the front cover is not required in order to replace the
slimline ODD or LSD module in the Multibay box.
"Removing the system fan holder" on page 76
Ê
"Removing the Multibay box" on page 296
Ê

12.5.3.2 Removing the defective slimline ODD

Ê Remove the slimline ODD from the Multibay box as described in section
"Removing the slimline ODD" on page

12.5.3.3 Removing the defective LSD module

Ê Remove the LSD module from the Multibay box as described in section
"Removing the LSD module" on page

12.5.3.4 Installing the new slimline ODD

Ê Install the slimline ODD into the Multibay box as described in section
"Installing the slimline ODD" on page
TX150 S8 / TX200 S7
Upgrade and Maintenance Manual
Accessible drives and LSD
Hardware: 10 minutes
297.
299.
289.
301