Cabling The 4X 3.5-Inch Hdd Extension Box; Installing Hdd Modules Into The 4X 3.5-Inch Hdd Extension Box; Concluding Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Server
Table of Contents

Advertisement

Hard disk drives / solid state drives
7.4.5.6

Cabling the 4x 3.5-inch HDD extension box

Ê Connect SAS and power cables to the 2x 3.5-inch HDD SAS backplane as
described in section
page
265.
Ê If applicable, connect slimline ODD and LSD module cables as described in
section
"Cabling the slimline ODD on the HDD extension box" on page
7.4.5.7

Installing HDD modules into the 4x 3.5-inch HDD extension box

Ê Close the front cover and reinstall the ID card as described in section
"Closing the server" on page
Ê Install HDD modules or HDD dummy modules into the additional HDD slots
as described in sections
and
"Installing a 3.5-inch HDD dummy module" on page
I
For detailed information on HDD mounting order, refer to section
inch HDD configurations" on page
7.4.5.8

Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section
fan holder" on page
Ê Reinstall the air duct as described in section
on page
100.
Ê Close the side / top cover as described in section
on page 113
(rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section
"Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page
336
"12x 3.5-inch HDD SAS backplane cabling" on
110.
"Installing a 3.5-inch HDD module" on page 271
387.
"Mounting the side cover" on page 120
131.
Upgrade and Maintenance Manual
277.
256.
"Installing the system
"Installing the system air duct"
"Mounting the top cover"
130.
128.
"Connecting the server to
TX300 S7 / RX350 S7
699.
"3.5-
(tower

Advertisement

Table of Contents
loading

This manual is also suitable for:

Primergy rx350 s7

Table of Contents