Toyota 1 MZ–FE Manual page 583

Check circuit opening relay.
Check voltage between terminal 3 of R/B No.6 (for circuit opening
relay) and body ground.
Check for open in harness and connector
between terminal 6 of R/6 No.6 (for circuit
opening relay) and body ground (See page IN–31).
1MZ–FE ENGINE – CIRCUIT INSPECTION
(1) Remove glove compartment
(See page EG2–309).
(2) Remove circuit opening relay from R/B No.6.
(1) Apply battery voltage between terminals 3
and 6.
(2) Check continuity between terminals 1 and 2.
Terminals 1 and 2
Replace circuit opening relay.
Measure voltage between terminal 3 of R/B No.6
(for circuit opening relay) and body ground when
engine is cranked.
Voltage: 9 –14 V
Check for starter signal circuit
(See page EG2–557).
EG2–583
Continuity