Toyota 1 MZ–FE Manual page 147

1MZ–FE ENGINE – ENGINE MECHANICAL
(i) Install the 4 main bearing caps.
(See step 4 on pages EG2–165)
12 Pointed Head Bolts:
Torque:
1 st 22 N–m (225 kgf–cm, 16 ft–lbf)
2nd Turn extra 902
Hexagon Head Bolts:
Torque: 27 N–m (275 kgf–cm, 20 ft–lbf)
NOTICE: Do not turn the crankshaft.
(j) Remove the main bearing caps.
(See procedures (a) to (c) above)
(k) Measure the Plastigage at its widest point.
Standard oil clearance:
0.026 – 0.046 mm (0.0010 – 0.0018 in.)
Maximum clearance:
0.06 mm (0.0024 in.)
If the oil clearance is greater than maximum, replace
the bearings. If necessary, replace the crankshaft.
HINT: If using a bearing, replace it with one having the
same number. If the number of the bearing cannot be
determined, select the correct bearing by adding to–
gether the numbers imprinted on the cylinder block
and crankshaft, then refer to the table below for the
appropriate bearing number. There are 5 standard
bearing sizes, marked '1', "2", "3", "4" and "5" accord–
ingly.
Cylinder block (A)
+
Crankshaft ( B ) _
Use bearing
EXAMPLE: Cylinder block "06" (A)
+ Crankshaft "08" (B)
= Total number 14 (Use bearing "3")
" ": Number mark
Total number
6–11 12–17 18–23
0–5
"1" "2"
EG2–147
24–28
"4" "5"