Toyota 1 MZ–FE Manual page 110

EG2–110
1MZ–FE ENGINE – ENGINE MECHANICAL
(c) Connect the water inlet pipe to the water inlet.
(d) Install the bolt holding the water inlet pipe to the
cylinder head.
Torque: 19.5 N–m (200 kgf–cm, 14 ft–lbf)
23. INSTALL CYLINDER HEAD REAR PLATE
(a) Install the rear plate and grand strap with the bolt and
nut.
Torque: 8 N–m (80 kgf–cm, 69 in.–lbf)
(b) Connect the vacuum hose to the air intake chamber.
(c) Connect the 2 vacuum hoses to the vacuum tank.
24. INSTALL NO–3 TIMING BELT COVER
(a) Check that the timing belt cover gaskets have no
cracks or peeling, etc.
If the gaskets do have cracks or peeling etc., replace
them using following steps.
(1) Using a screwdriver and gasket scraper, remove
all the old gasket material.
(2) Thoroughly clean all components to remove all
the loose material.
(3) Remove the backing paper from a new gasket
and install the gasket evenly to the part of the
belt cover shaded black in the illustration.
NOTICE: When joining gaskets, do not leave a gap be–
tween them. Cut off any excess gasket.
(4) After installing the gasket, press down on it so
that the adhesive firmly sticks to the belt cover.
(b) Install new gaskets to the No.3 belt cover.
(c) Install the belt cover with the 6 bolts.
Torque: 8.5 N–m (85 kgf–cm, 74 in–lbf)